The driest week yet, between non-craft work, finalizing the owl pattern, and preparing to teach the second session of my crochet class. I’m expecting time to work on non-deadlined projects at the end of this week – fingers crossed!
Totals:
Did you have a more productive FYDP week?
Only one item finished this week. I’m busy with non-craft work, but also, while I may yet dismantle more projects, the obvious abandonments are done now. No project is finished more quickly than the one you just take apart!
Totals:
The last in the series of beading patterns from my distant past.
For a while I had a haircut that looked good with bobby pins, and I started collecting interesting pins to wear. It didn’t take long to start coming up with my own. For each pin you need an 8-10″ length of 32-gauge wire (less if you are skilled at working with wire; they don’t take nearly that much, it’s just hard to manipulate much less), a bobby pin, and epoxy. Gorilla glue or similar should work in place of epoxy, although be careful not to use much since it expands as it sets.
For the 5-point star: 10 small seed beads.
Make a bend in the wire about 1.5″ in from the end. String a bead onto that bend and take both ends of the wire through a second bead. *String two beads onto the longer end and take the wire back through the first of the two* four times for a total of 5 points (see diagram below left). Twist wire ends together. Wire to bobby pin, trim ends, secure with epoxy.
For the diamond: 4 bugle beads, 1 large rocaille.
String 4 bugles on wire and loop one end back through the farthest 2 bugles to form a closed diamond with the wire ends sticking out at opposite points. Pull taut and pass the wire ends through the rocaille from opposite directions (see diagram above right). Wire to bobby pin, trim ends, and secure with epoxy.
With the bobby pins in the photo are two beaded combs; at times my hair is a good length for those. I didn’t wrap the thread in the same way on each, but on both each bead is secured by two separate stitches.